Cassettes and Axles

Two updates: firstly, I bought a new seven-speed freewheel cassette. E-bay special. I went for a cheapie one and I totally regret it; it’s considerably heavier than the pukka Shimano 6-speed it’s replacing and just doesn’t smack of the same quality. Who’d have thunk it? Still, it’s on and if I want to splash £20 later in the build I can always switch it. Weight in the hub of the wheel makes a difference to rollability.

Secondly, I came to a conclusion about bottom brackets! The replacement crankset requires an axle with internal thread; the original wax external. (Essentially: the original used nuts to fix it on whereas the replacement uses bolts.)This means I cannot re-use the original The trade-off went something like this:

  1. Reuse the bearings & cups; purchase an ew replace with an internal axle. Pros: much reuse of the original components, so retaining soul and saving landfill; cheap!
  2. Buy sealed bearing BB replacement. The Shimano UN-55 is a great example; there are lots of others out there catering to the fixie, BMX et al communities. Pros: it’s sealed so it should last forever; cons: they’re quite expensive and need some more expensive tools (which I’ll only use once).

I decided on Option 1. I don’t think I’ll be riding enough, or in poor enough weather, for a sealed BB to pay itself back and I’d like to retain some soul and save some landfill. (As an aside, or similar reasons I’ll be reusing my original quill stem.) A friend offered me the loan of the tools but all in all it’s cheaper and easier to just replace the axle.

The next fun part was determining the axle size. There are four critical measurements on a BB axle:

  1. The length of the axle, end-to-end
  2. The distance between the non-drive-side end and the shoulder of the inner race;
  3. The distance between the non-drive-side and drive-side race shoulders
  4. The distance between the drive-side race shoulder and the drive-side edge.

There are so many options, some of which are 1mm apart and precise measurements are tricky. It was about half an hour before I saw the letters “3L” stamped on the side, which turned out to be all I needed.

The kit all arrived this weekl The replacement axle is a few grammes lighter than the original; with bolts and washers, it’s the same as the original without nuts. So basically no different..

In other news, the frame and forks are at the workshop and they’re doing them this week. Should be back by Friday; very much looking forward to how the turn out! That’s when the real re-building fun begins.