Get your cranks off, baby

I had found there is little in this world quite as satisfying as removing a stuck-on crank. It’s like that feeling you get when removing the protective film from a new mobile phone, achieving the gift-wrap-glide or watching a slinky on a treadmill.

Postie brought me presents today. First up was the crank puller. I was reflecting that, depending on what I cranks I put on, I may never user this tool ever again and I probably could have borrowed one – but hey ho, its outline looks good on the tool wall. Pulling a crank is shown very well at https://www.youtube.com/watch?v=64m1mmPFxcc; that bit at 3:00? Ooh….

With the cranks and locknut off, the cups came out easily and with them the axle. As expected, the bearings were properly manky with barely a drop of grease to be seen and plenty of dirt. I now need to decide whether to clean, re-grease and replace the bearings – assuming they’re in good nick (I haven’t had a proper look) or whether to install a modern square taper sealed cartridge BB like those found at https://www.sjscycles.co.uk/square-tapered-other/ Given that a packet of BBs is only half the price of a sealed cartridge I’ll probably opt for the latter.

The second postie present was a set of thread pitch gauges, using which I have confirmed my BB uses 24tpi threads. The last detail is important; old Raleighs often used 26tpi and that would have made sourcing a replacement tricky. Happily I can rest easy! It’s also 68mm and English threaded (lefty-tighty, righty-loosy on the drive side).

For completeness, I also removed the gear cable guide from the underside of the BB and the iconic Raleigh Heron badge from the front. The strip is complete! All I need now before heading to the blasters is to sort out these wretched forks…