Bearings and Bendings
In between other tasks today, I stripped, cleaned and re-greased the bearings on the front wheel (I had done the rear previously). They started mucky, they ended beautifully clean!
All I need now is a tool to remove my cranks and that’s part one done. Tools used: 13mm cone wrench, adjustable spanner (imperial) and a tub of grease.
After a nudge from a friend, I inspected the frame. The forks are quite bent; each blade is bent back and each by a different amount. You can see some bend in the picture below. Not sure what to do about this. I might just deal with it – after all I never really noticed, other than having to be careful when mounting wheels and not turning too sharply lest I foul on my foot. The rear, however…
I used a broom handle to check the frame alignment. You run the handle down next to the head tube and seatpost and inside the rear stays, right down to the dropout. Measure the distance from the handle to the dropout. Repeat both sides; the distance should be the same. It wasn’t; the left side was 15mm away; the right 36mm! A major imbalance. Furthermore, I said previously I didn’t want to cold-set to 130mm spacing at the rear; however, it turns out that someone else got there first.

The gap from centre to each side should be 66mm, having originally been 63mm. A bit of maths tells me it’s now 56mm on the left and 76mm on the right; so not only has the frame been widened, both stays have been pushed to the right.
This leaves me in a quandary. I’m not going to try and cold-set the frame back to 126mm; leaving it as-is gives me loads of options including freewheel-based Campy 7-8 speed or freehub-based 8 speed and up. However, I ought to centre it so that the frame is at least aligned which means moving both stays by 10mm – but then it doesn’t shimmy and I can ride it hands-free so i’m half tempted to leave it.
Wider stays meant I was able to put my (knackered) Fulcrum RQ Carbons in, just for kicks and giggles. Talk about era clash. So wrong it’s right!


